I just got the app so it’s possible I’m just missing something, but I’m not able to edit connections without deleting the component completely. Most commonly, I come across this with the jumper wires. It would be nice to be able to pick up one end of the wire and place it in a new slot, rather than deleting the wire completely and replacing two endpoints, especially when the wires go a long ways or you have multiple connections to adjust. On a similar note, I’ve found the ‘Corners’ option for placing jumper wires to be pretty difficult to use; sometimes corners get placed when I’m trying to pan or zoom or rotate the camera, sometimes I’ll try to place the end in a slot and end up just placing a bunch of corners until it finally lands in the slot, oftentimes I’ll try to place a corner and end up placing the end in a slot, at which point I have to delete the wire and start over. It would be great if you could choose the two endpoints and then drag points on the wire to make corners. Other than that, I’m really enjoying this app. I haven’t played around with breadboards/circuits since high school and it’s been a lot of fun getting back into it!